INCRUSTACIONES ONLAY E INLAY PDF

Las incrustaciones inlay y onlay requieren menos reducción dentaria que los resina, puentes, incrustaciones intracoronarias y extracoronarias e incluso. de sonido de inlays / onlays / veneers cerámicos e inlays de oro colado [ ] y coronas parciales. la eficacia de las incrustaciones cerámicas en los dientes [.. .].

Author: Meztigal Taujora
Country: Congo
Language: English (Spanish)
Genre: History
Published (Last): 11 September 2012
Pages: 473
PDF File Size: 8.16 Mb
ePub File Size: 6.61 Mb
ISBN: 391-6-59017-982-9
Downloads: 45852
Price: Free* [*Free Regsitration Required]
Uploader: Vuzahn

The preparation of inlays and onlays mainly follows the same basic concepts of indirect restorations. The investment material must produce enough expansion to compensate for shrinkage of the metal on solidification and should be slightly porous to allow for dissipation of released gases.

Just as inlays, onlays are fabricated outside of the mouth and are typically made out of gold or porcelain. There are no obvious contrast between the two. The restoration is then light-cured in the tooth before being removed from the tooth to be further inla.

Inlay / Onlay | Wahl Dental Ceramics

The tooth has not fully erupted and continued active and passive eruption can cause unfavourable margins when the tooth is fully through as the patient is still undergoing skeletal development.

Ceramic offers a more aesthetically pleasing restoration colour than previous gold and amalgam restorations. Luting cements can have a low modulus or a high modulus. Alumina core porcelain [22]. It can also be used if there is minimal contour of remaining coronal tooth tissue with little retention. Firstly, a sub-structure made of alumina powder and modelling fluid is built on the special die. Opposed to this, direct composite filling pastes shrink a inctustaciones percent in volume during hardening.

Alternative materials such as porcelain were first described being used for inlays back in A high-speed tapered diamond bur has the most convenient shape to prepare the buccal, lingual and proximal reduction of the tooth. This can protect remaining tooth structure.

The Journal of Prosthetic Dentistry. When preparing a cavity to retain an indirect restoration we risk damage to the nerve supply of a vital tooth. All of the benefits of an inlay are present in the onlay restoration.

The wax is embedded into an investment material with a sprue former — this forms a passage for molten metal to be poured through into the cylinder.

  HIDROSTATSKI TLAK PDF

This page was last edited on 24 Decemberat Inlays and onlays are used in molars or premolars, when the tooth has experienced too much damage to support a basic filling, but not so much damage that a crown is necessary.

This can lead to shrinkage stress and rarely to marginal gaps and failure. Oxford, London, Edinburgh, Melbourne: When the patient is not concerned with aesthetics, such as in posterior teeth, gold can provide the properties needed. There are two ways this can be done, either by blocking the undercuts out with an adhesive restorative material or by removing tooth tissue to create the divergent cavity needed.

Inlay / Onlay

In this case, this is a beneficial character as it helps us to identify the presence of an undercut which then can be removed. Biologic width Centric relation Crown-to-root ratio Maximum intercuspation Occlusion vertical dimension mutually protected Dahl concept Masticatory force Neutral zone.

It is possible for these indirect restorations to be provided in one visit. Evidence Fuzzi and Rapelli has shown greater failure of Onlays and Inlays in molars than premolars over an Casting methods include the use of steam pressure or a centrifugal system.

The container, or casting cylinder, is then placed in a furnace to burn out the wax and what is left is a hollow shape ready for molten metal to be poured into. A Review; ; J Dent Biomech; vol. However, the disadvantage of super curing is that it leaves less reactive resin groups to bond to the cement and therefore the strength of bond will be less.

Inlays and onlays

The first common step is always to take an impression of the tooth preparation — either by scanning it using an intraoral scanner or by taking a conventional impression using polyvinyl siloxane. Patients need to be incrustacionew to cope with dental impressions as these are required for the fabrication of the indirect restoration.

Then, a composite restoration is built up directly on the preparation, allowing it to take the shape of the cavity. Instead, the tooth preparation is coated with a layer of separating material such as glycerin first. However, in the main the subsequent caries around a restoration is because the caries risk has not been reduced.

  INTUBACION PACIENTE DESPIERTO PDF

High failure rates were associated with teeth that had previous root canal treatmentand with patients who exhibit para-functional habits oblay as bruxismor teeth clenching. Retrieved incrusstaciones ” https: Indirect restorations are contraindicated in patients under 16 as the pulp chamber is still large and wide dentinal tubules increase the stress on the pulp. Sometimes, a tooth is planned to be restored with an intracoronal restorationbut the decay or fracture is so extensive that a direct restorationsuch as ijcrustaciones or compositewould compromise the structural integrity of the restored tooth or provide substandard opposition to occlusal i.

If a tooth has extensive caries or tooth surface incrustaciomes which would provide difficulty bonding an inlay or onlay then it might be more appropriate to consider a full coverage extra coronal restoration.

The best instrument to use for this is a high-speed diamond fissure bur and the reduction should follow the inclination of the cusps and grooves as this will allow the preservation of more tooth tissue.

In the majority of clinical situations an inlay preparation is being made from a tooth ijlay already has a Class II restoration and is being prepared to protect the tooth.

The milling process uses pre-fabricated blocks of restorative material, e. However, this might be only the case for gold. Clinical, Cosmetic and Investigational Dentistry. Further strengthening of the material can be done by applying zirconium oxide. When decay or onlya incorporate areas of a tooth that make amalgam or composite restorations inadequate, such as cuspal fracture or remaining tooth structure that undermines perimeter walls of a tooth, an onlay might be indicated.

Applied dental materials 9th ed. However, ceramic used as a restorative material without metal reinforcement have reduced strength and more prone to failure.

Gold restorations have been around for many years and have an excellent track record.